freezing risk EMERGENCY PROCEDURE

Depending on the type of spa you own, follow the appropriate procedure below. If in doubt, contact us directly.

Spas with multiple compartments (Dynasty and others)

Open front spa panel
Installer two 1500 watts ceramic heaters. Do not use a space heater with a heating element for this is too direct and will melt the pipes.
If the space is sufficient, close the panels
If not, place panels on either side, in an angle, in order to create a wall. Place a tarp over the skirt and hold in place with the spa cover. You can also use the central panel to create a wall and keep as much of the heat under the spa. Make sure your tarp is held down and is a sealed as
possible.
Make sure to block all ventilation grills around your spa skirt.

Open front spa panel
Installer two 1500 watts ceramic heaters. Do not use a space heater with a heating element for this is too direct and will melt the pipes.
If the space is sufficient, close the panels
If not, place panels on either side, in an angle, in order to create a wall. Place a tarp over the skirt and hold in place with the spa cover. You can also use the central panel to create a wall and keep as much of the heat under the spa. Make sure your tarp is held down and is a sealed as
possible.
Make sure to block all ventilation grills around your spa skirt.

Spas with only one compartment (Catalina, Coast, Four Winds, Jacuzzi, La Spas, MAAX, Sundance, Viking, VITA and others)

Spas with exterior plombing (Beachcomber and others)

Open front spa panel
Installer one 1500 watts ceramic heater. Do not use a space heater with a heating element for this is too direct and will melt the pipes.
If the space is sufficient, close the panels
If not, place panels on either side, in an angle, in order to create a wall. Place a tarp over the skirt and hold in place with the spa cover. You can also use the central panel to create a wall and keep as much of the heat under the spa. Make sure your tarp is held down and is a sealed as possible.
Make sure to block all ventilation grills around your spa skirt.

Open electronic compartment (the step)
Slide in one 1500 watts ceramic heater. Do not use a space heater with a heating element for this is too direct and will melt the pipes.
Set step back into place, and make sure to bloc all ventilation traps, located at the back, in order to keep as much as the heat in the area as possible.

Open electronic compartment (the step)
Slide in one 1500 watts ceramic heater. Do not use a space heater with a heating element for this is too direct and will melt the pipes.
Set step back into place, and make sure to bloc all ventilation traps, located at the back, in order to keep as much as the heat in the area as possible.

Open front spa panel
Installer one 1500 watts ceramic heater. Do not use a space heater with a heating element for this is too direct and will melt the pipes.
If the space is sufficient, close the panels
If not, place panels on either side, in an angle, in order to create a wall. Place a tarp over the skirt and hold in place with the spa cover. You can also use the central panel to create a wall and keep as much of the heat under the spa. Make sure your tarp is held down and is a sealed as possible.
Make sure to block all ventilation grills around your spa skirt.